Product Description
The voltage regulator is used to automatically regulate voltage level. It will reduce the input voltage to the level you’re targeting and keeps that same level while supplying power to your sensors.
MB7986 Voltage Regulator Board
| Pricing rules for MB7986 Voltage Regulator Board | |
| Quantity | Cost Per Product |
|---|---|
| 5 - 9 | $18.343 |
Product Specifications
Voltage Range
3V – 30V
Mechanical Measurements
0.705″ wide x 0.454″ tall x 0.130″ thick.
Pin Spacing 0.100″
Compatibility
The Voltage Regulator Board is compatible with the following sensor lines:
- HRXL‑MaxSonar‑WR
- HRXL‑MaxSonar‑WRS
- HRLV-MaxSonar-EZ
- HRLV-ShortRange-EZ
- LV-MaxSonar-EZ
- XL-MaxSonar-EZ
- I2CXL‑MaxSonar‑WR
- XL‑MaxSonar‑WR
- XL‑TrashSonar‑WR
- LV-ProxSonar-EZ
- Parksonar-EZ
Component Overview
- Volume Pricing (10 or more units): Contact MaxBotix Inc.
Product Documentation
Mechanical Measurements
0.705″ wide x 0.454″ tall x 0.130″ thick.
Pin Spacing 0.100″
Pinout
Connect the pins of the sensor to the OUT side of the MB7986.
Pin 1 of the sensor connects to Pin 1 of the voltage regulation board.
This repeats for each pin of the sensor. (i.e. Pin 2 to Pin 2, etc.)
Connect the pins of the reading device to the IN side of the MB7986.
| From Device to IN | OUT to Sensor |
| Pin 1 – Pass Thru | Pin 1 – Pass Thru |
| Pin 2 – Pass Thru | Pin 2 – Pass Thru |
| Pin 3 – Pass Thru | Pin 3 – Pass Thru |
| Pin 4 – Pass Thru | Pin 4 – Pass Thru |
| Pin 5 – Pass Thru | Pin 5 – Pass Thru |
| Pin 6 – V+3V*-30V | Pin 6 – V+5V* |
| Pin 7 – GND | Pin 7 – GND |
*Input voltage from 3V-5V is pass through voltage which may experience up to a 0.1V drop.
Part Numbers
Related Products
-
MB7954 Shielded Cable
The MaxSonar Connection Wire is used to reduce interference caused by electrical noise on the lines. This cable is a…
View Product From: $3.45
Read More -
-
MB7985 Radio Bridge Connector
To ensure easy integration with the Radio Bridge interface, we provide a 5ft cable to connect your sensor to the LoRaWAN Bridge.
View Product $0.00 -
P-Option *
Coats the aluminum transducer of our WR sensors in Parylene to help prevent corrosion. Select this option on the applicable product page to purchase.
View Product $46.00
