Mounting Hardware for our Outdoor Ultrasonic Sensors
| Pricing rules for MB7950 Mounting Hardware | |
| Quantity | Cost Per Product |
|---|---|
| 5 - 9 | $3.00 |
| 10 - 49 | $2.70 |
| 50 | $1.80 |
The MB7950 Mounting Hardware is selected for use with our sensors in a 3/4″ NPS housing style. The MB7950 Mounting Hardware gives customers easy access to the hardware needed for through hole mounting. The mounting hardware includes a steel lock nut and two O-ring (Buna-N and Neoprene) each optimal for different applications.
This accessory is compatible with the following sensor lines that MaxBotix Inc., sells.
MB7950 Datasheet……………………MB7950 Mounting Hardware Datasheet
All part numbers are a combination of a six-character base followed by a dash and a three-digit product code. Please review the following table for more information on the three-digit product code.
| M | B | 7 | 9 | 5 | 0 | – | 0 | 0 | 0 | ||||||||||
| Base | |||||||||||||||||||
| Housing Style | |||||||||||||||||||
| 0 | Not Applicable | ||||||||||||||||||
| 1 | 3/4″ NPS WR | ||||||||||||||||||
| 2 | 3/4″ NPS WRC | ||||||||||||||||||
| 3 | Ultra Compact | ||||||||||||||||||
| 4 | Ultra Compact Flush Mount | ||||||||||||||||||
| 5 | 1″ NPS | ||||||||||||||||||
| 6 | 1″ BSPP | ||||||||||||||||||
| 7 | 30MM 1.5 | ||||||||||||||||||
| 8 | Extended Horn | ||||||||||||||||||
| Options Selected | |||||||||||||||||||
| 0 | No Options (Bagged) | ||||||||||||||||||
| 1 | F-Option | ||||||||||||||||||
| 2 | P-Option | ||||||||||||||||||
| 3 | F-Option and P-Option | ||||||||||||||||||
| 4 | No Options (Trayed) | ||||||||||||||||||
| 5 | TTL (Bagged) | ||||||||||||||||||
| 6 | TTL (Trayed) | ||||||||||||||||||
| Wire Attach | |||||||||||||||||||
| 0 | No Wire Attach | ||||||||||||||||||
| 1 | Wire Attached | ||||||||||||||||||
The following table displays all of the active and valid part numbers for this product.
| Active Part Numbers |
| MB7950-000 |
Yields a stronger seal for IP68 compliance and operation near harsh chemicals. Select this option on the applicable product page to purchase.
Connects shielded cable to the pin-out below a sealed cap providing a full IP67 seal. Select this option on the applicable product page to purchase.
Coats the aluminum transducer of our WR sensors in Parylene to help prevent corrosion. Select this option on the applicable product page to purchase.
Improves snow depth measurements and detection range for people with select sensors. Select this option on the applicable product page to purchase.
